Notes on the Installation, Initial Start-up, Operation
Radio Receiver FSE 514
Page 14 / 18
BE-514_I-V1-3-FCC.doc.doc [ Word 2000 ] MB
HBC-radiomatic GmbH • D-74564 Crailsheim • GERMANY
30-04-2003
Information and specifications subject to change without notice.
Radio System
4
Fault Correction
Note:
Check the functions using the cabin or cable controls first !
Problem
Possible Cause
Remedy
The transmitter is operating
properly, however the
crane does not carry out
the control commands.
−
The receiver is not
connected to the mains
supply.
−
There is no radio contact
between transmitter and
receiver.
−
The command "crane
ON" has not been
activated.
−
Check the mains cable
leading to the receiver.
−
Check the fuses in the
receiver housing.
−
Check receiver functions
using the LEDs in the
indicator lamp panel on
the receiver.
Some command statements
are not carried out.
−
The receiver is defective.
−
The connection between
crane / machine and
receiver is faulty.
−
Ensure that the
connection cable is
securely fastened.
−
If necessary, call a
service engineer or
technician.
