The qualifications of the staff for the different tasks are mentioned below:
Operator
The operator is instructed by the operating company about the assigned tasks and possible
risks in case of improper behaviour. Any tasks which need to be performed beyond the opera-
tion in the standard mode must only be performed by the operator if it is indicated in these
instructions and if the operating company expressively commissioned the operator.
Electrical specialist
Due to his professional training, knowledge and experience as well as his knowledge of respec-
tive standards and regulations the electrical specialist is able to perform works on the electrical
system and to recognise and avoid any possible dangers himself.
The electrical specialist is specially trained for the working environment in which he is working
and knows the relevant standards and regulations.
Specialist staff
Due to his professional training, knowledge and experience as well as his knowledge of rele-
vant regulations the specialist staff is able to perform the assigned tasks and to recognise and
avoid any possible dangers himself.
Instructed persons
Instructed persons were instructed by the operating company about the assigned tasks and any
possible risks in case of improper behaviour.
Qualification of employees
Target group
This manual applies to
•
the operators,
•
the users,
•
the maintenance staff.
Therefore, the warning notes refer to both operation and maintenance of the polishing machine.
Determine clearly and make a permanent decision in who will be responsible for the different
activities on the machine (operation, maintenance and repair).
Vague and unclear assignment of responsibilities constitute a safety hazard!
Always disconnect the main plug of the polishing machine. This will prevent it from being used
by unauthorized persons.
Additional qualification requirements
For work on electrical components or equipment, there are additional requirements:
•
This work should only be carried out by a qualified electrician or a person working under the
instruction and supervision of a qualified electrician.
Before carrying out work on electrical components or operating units, the following meas-
ures must be taken, in the order given:
-
disconnect all poles
-
ensure that the polishing machine cannot be turned on again
-
check that there is no voltage
Summary of Contents for PMS 150
