Assembly
Delivery volume
When the polishing machine is being delivered, please check immediately that it has not been
damaged during transportation and that all components are complete. For this purpose, take all
parts out of the box and compare them to the following list.
•
Polishing machine
•
2 x polishing wheels (mounted)
•
operating manual
Installation and assembly
Site requirements
Organize the working space around the polishing machine according to the local safety regula-
tions.
INFORMATION
In order to provide for good functionality and high machining accuracy as well as long durability
of the machine the site should fulfill certain criteria.
Observe the following items:
The device must only be installed and operated in dry ventilated places.
Avoid places nearby machines generating chips or dust.
The site has to be vibration-free, i.e. at a distance from presses, planing machines, etc.
The substructure has to be appropriate for polishing machine. Also make sure that the load
bearing capacity and the evenness of the floor are appropriate.
The substructure has to be prepared in a way that possibly used coolant cannot penetrate
into the ground.
Protruding parts such as stops, handles, etc. need to be secured by measures provided by
the customer if necessary in order to avoid dangers for persons.
Provide sufficient space for assembly and operating staff as well as for material transport.
Also allow for accessibility for setting and maintenance works.
Make sure that the mains plug of the turning machine is freely accessible.
Provide for sufficient illumination (minimum value: 500 lux, measured at the tool tip). In case of
little intensity of illumination provide for additional illumination i.e. by a separate workplace illumi-
nator
Changing the polishing wheels
Unplug the main plug from the socket.
Secure the polishing machine against unauthorized starting-up.
Unscrew the acron nut on the left polishing wheel, (right hand thread M16).
Unscrew the acron nut on the right polishing wheel, (left hand thread M16).
The bolted connection can easily be loosened by light beats on the key which is being used to
unscrew the acron nut. Due to safety reasons, there is nothing to hold-on in the construction
when loosening the acron nuts.
Pull the polishing wheel off the driving shaft.
Mount the new polishing wheels. Make sure that the clamping wheels are in the right position.
Check the orientation in the centric run by manual turning of the polishing wheels.
Fasten the acron nut by an open-jaw spanner.
Perform a trial run.
WARNING !
Only use acron nuts to fasten the polishing wheels. The shaft extensions must be
covered.
Summary of Contents for PMS 150
