Index
A
Acquisition .................................................. 84, 131
Pause .......................................................... 132
Run .............................................................. 132
Stop ............................................................. 132
Acquisition and Storage
Pre-trigger sweeps ...................................... 135
Sweeps ........................................................ 134
Alarm
Detector ....................................................... 164
Output .................................................. 164, 184
Alarm trigger, see Trigger Modes Dual ........... 148
Aliasing ............................................................. 142
B
Balancing, bridge .............................................. 271
Basic qualifier ................................................... 153
Basic trigger ..................................................... 148
Batteries
Disposal ......................................................... 69
Introduction .................................................... 61
Recharging .................................................... 68
Removal and replacement ............................ 62
Remove/replace the battery from the back-
plane .............................................................. 63
Remove/replace the battery from the PC sec-
tion ................................................................. 65
Battery lifetime .................................................... 61
Bin size ............................................................. 140
Binary clock base ............................................. 139
Binary marker card ........................................... 294
Binary marker cards
Configure the Timer/Counters in Perception ...302
Connector pinning GN6470 and GN4070 ... 296
GN4070 Binary marker HV card .................. 295
GN4070 Connectors and pinning ................ 306
GN6470 and GN4070 Counter mode pinning ...298
GN6470 and GN4070 Frequency (RPM)
mode pinning ............................................... 299
GN6470 and GN4070 Quadrature (position)
mode pinning ............................................... 300
GN6470 Binary marker card ........................ 294
Binary marker HV input .................................... 295
Boot setup ........................................................ 809
Creating the back copy ................................ 854
Prerequisites ............................................... 853
Recovery tools disk ..................................... 812
Solid State Drive layout ............................... 810
Touch screen calibration ............................. 839
Bridge amplifier ................................................ 249
Balancing ..................................................... 271
Completion .................................................. 251
Completion/Full ........................................... 258
Completion/Half ........................................... 259
Completion/Jumper ..................................... 251
Completion/Quarter ..................................... 261
Configuration ....................................... 249, 253
Connector reference card ............................ 256
Connectors .................................................. 251
Excitation ..................................................... 263
Sense .................................................. 263, 264
Shunt calibration .................................. 251, 267
Bridge input card .............................................. 249
C
Calculating maximum fiber cable length ........... 945
Calibration (shunt) .................................... 251, 267
Calibration (system) ......................... 98, 808, 1007
Cautions ............................................................. 19
CE Declaration of conformity .............................. 59
Channel alarm .................................................. 164
Channels .......................................................... 131
Circular recording ..................................... 135, 138
Clock Base
Binary .......................................................... 139
Decimal ....................................................... 139
Completion (bridge) .......................................... 251
Jumper ........................................................ 251
Configuring an encoder with direction and reset ...953
Activate Digital I/O channels with Perception ....
From encoder to level converter .................. 953
From level converter to Digital I/O connector
on the mainframe ........................................ 956
To activate Channel 8 or Channel 9 in Per-
ception ......................................................... 959
Configuring and using the bridge amplifier ....... 257
GEN3i
I3763-3.1 en HBM: public
1149
