Dual
Dual Sweep Specification
Pre
-
trigger segment
0% to 100% of selected sweep length
If trigger occurs before the pre
-
trigger segment is recorded, the pre
-
trigger segment is
truncated to recorded data only.
Delayed trigger
Maximum 1000 seconds after a trigger occurred. The sweep is recorded immediately after
a delayed trigger time with 100% post
-
trigger after this time point.
Maximum number of sweeps
200 000 per recording
Maximum sweep rate
400 sweeps per second
Sweep re
-
arm time
Zero re
-
arm time, sweep rate limited to 1 sweep per 2.5 ms
Sweep stretch
User selectable On/Off
When enabled, any new trigger event occurring in the post
-
trigger segment of the sweep
restarts the post
-
trigger length. If, upon the detection of a new trigger, the extended post
-
trigger does not fit within the sweep memory, sweep stretch does not happen. The maximum
sweepstretch rate is 1 sweep stretch per 2.5 ms.
Sweep storage
In dual mode, the storage of the continuous data is prioritized above the storage of the
sweep data. If enough storage rate is available, the sweep storage is started immediately
after the trigger for this sweep has been detected. Sweep memory becomes available for
reuse as soon as storage of the entire sweep for all enabled channels of this card has been
completed. Sweeps are stored one by one, starting with the first recorded sweep.
Sweep storage rate
Determined by the continuous sample rate, total number of channels and mainframes,
mainframe type, Ethernet speed, PC storage medium and other PC parameters. For details,
please refer to mainframe datasheet.
Exceeding sweep storage rate
Continuous recorded data is not stopped, trigger event markers are stored in recording and
no new sweep data is stored. A new sweep is recorded as soon as enough internal memory
is available to capture a full sweep when a trigger occurs.
Dual Continuous Specifications
Continuous FIFO memory
Used by enabled channels to optimize the continuous streaming rate
Maximum recording time
Until storage media filled or user selected time
Maximum aggregate streaming rate per
mainframe
Determined by mainframe, Ethernet speed, PC storage medium and other PC parameters.
For details, please refer to the mainframe datasheet.
When the average aggregate streaming rate is exceeded, the sweep storage speed is
automatically reduced to increase the aggregate streaming rate until the sweep storage is
stopped completely.
Exceeding aggregate storage rate
When a streaming rate higher than the aggregate streaming rate of the system is selected,
the continuous memory acts as a FIFO. As soon as this FIFO fills up, the recording is
suspended (no data is recorded temporarily). During this period, the internal FIFO memory
is transferred to the storage medium. When the internal memory (Continuous and Sweep
memory) is completely empty, the recording is automatically resumed. User notifications
are added to the recording file for post recording identification of storage overrun.
Fiber optic link
Light source
Class 1 laser product
Transfer rate
2 Gbit/s
Wavelength
850 nm
Connector
LC duplex on GN401
SCRJ/IP67 duplex on GN110, GN111, GN112 and GN113
Cable
Isolation
10
15
Ω/m
Maximum length
800 m (26245 ft); using ISO/IEC 11801 type OM2, OM3 or OM4 cable and no extra couplers.
Each extra LC
-
LC or SCRJ
-
SCRJ coupler reduces cable length by approximately 100 m
(328 ft)
Type
Duplex Multi Mode, 50/125 μm, ISO/IEC 11801 type OM2
GEN3i
I3763-3.1 en HBM: public
395
