5.3
Fuse requirements and protection
GEN3i is equipped with replaceable fuses. The fuse positioning stated in this
manual and on the GEN3i must be followed. Additionally for the UK, a fuse
should be fitted in the line supply plug.
WARNING
Any interruption of the protective conductor inside or outside the
apparatus is likely to make the apparatus dangerous. Intentional
interruption is prohibited.
When the apparatus is connected to its supply, terminals may be live, and
opening covers to remove parts is likely to expose live parts.
Whenever it is likely that the protection has been impaired, make the apparatus
inoperative and secure it against any unintended operation.
For example, if the apparatus shows visible damage or has been subjected to
severe transport stresses, the protection is likely to be impaired.
It is the responsibility of the user to ensure the safety of any accessories used
with the equipment, such as probes.
WARNING
ELECTRICAL SHOCK HAZARD! Do not remove covers. Refer servicing to
qualified individuals.
WARNING
Connect a protective ground wire as an additional safety measure to
prevent electric shock or damage to GEN3i.
Using this device properly depends on the user reading all instructions and
labels carefully.
If the instrument is used in a manner not specified by HBM, the protection
provided by the instrument can be impaired.
GEN3i
I3763-3.1 en HBM: public
73
