B.10
Mainframe adapters
B.10.1
G070A Torque/RPM adapter
l
Connect up to two torque transducers
l
Connect to T12/T40B using standard cables
l
RS422 differential input signals for highest immunity
l
Connect to GEN DAQ mainframe using standard cable
l
Dual signal output for dual use with test cell control system
l
Low latency outputs
l
Power T12/T40B from adapter (Power supply not included)
l
Connect to binary, frequency or a,b,z based sensors using RS422
signals
The Torque/RPM adapter enables the connection of HBM
’
s T12, T40B or similar torque transducers to GEN DAQ
mainframes. The use of differential signals improves the immunity to external disturbance especially when using long
cables in electrically noisy environments. For easy connectivity of transducers the adapter can optionally route power
over the transducer cables, this avoids the need of separate power cables. This power input is separately connected
to the adapter per transducer.
Whenever a test cell control system requires parallel access to the torque and/or speed signals, the adapter
reconditions the incoming signals and outputs all input signals as RS422 differential signals.
All outputs come with low latency to support real
-
time safety monitoring applications.
Each of the torque and speed inputs are directly connected to the GEN DAQ high resolution Timer/Counter channels.
The speed input supports direction and reference pulse to enable rotational angle measurement. The torque input
supports shunt to optimize accuracy.
In addition to HBM torque sensors, the adapter allows use with any binary, frequency or a, b, z based sensor. E.g.
for more accurate/higher resolution rotational speed and angle measurement, standard industrial incremental
encoders with RS422 signals can be used simultaneously with the HBM torque transducer.
All event inputs provided by the GEN DAQ mainframe that are not used to connect to the torque and speed signals
are rewired to a pin compatible event I/O connector.
GEN3i
762
I3763-3.1 en HBM: public
