E.5
Recovery partition creation
To create/restore the recovery partition, a USB disk/stick with a back
-
up copy
of the recovery partition is required. If this back
-
up copy has not been made or
is lost, a copy can be ordered from HBM service.
E.5.1
Using the Integrated System Recovery USB Disk
1
Power off the mainframe.
2
Connect the mouse and keyboard.
3
Insert the USB disk in one of the USB 2.0 ports (The USB3.0 ports will not
allow the restore process to finish correctly).
4
Power on the system and keep the
F7
function key pressed until the
following dialog appears.
Figure E.40:
Listed boot devices
A
Name of installed Solid State Drive
B
Name of USB disk/stick attached to your system
If the attached USB disk/stick does not appear, it was installed the system
was powered on or the USB disk/stick is not bootable. Correct the issue,
power off the system and restart from the beginning.
Use the arrow keys to select the USB disk/stick in the list of boot devices
and press enter. The system will boot the recovery partition creation.
A disk partition inspection is started.
l
If a recovery partition is detected, the
Recovery Partition Restore
is
started. For more information, please refer to "Starting recovery partition
restore" on page 858.
l
If the Recovery partition is not detected, the
Recovery Partition
Creation
is started. For more information, please refer to "Starting recovery
partition creation" on page 857.
GEN3i
856
I3763-3.1 en HBM: public
