SPECIFICATIONS
Lifting capacity: 360 Kilogramm
Width:
480 mm.
Minimum height
220 mm.
Maximum height
780 mm.
Overall length
2215 mm.
INSTALLATION
Unpack the crate and check the contents. In case of missing or damaged
parts please call HBM Machines.
-- Mount the roll-on ramp (31) on the end of the support plateau (32)
-- Mount the front wheels (35 and 47) at the front side of the plateau (32).
Use the bolts (33), Rings (34) and nuts (38).
-- Mount the faceplate (39) using the bolts (33), Rings (34) and nuts (38).
PREPARATION FOR FIRST USE
--Leave the pump for at least an hour. The oil can now release its air
bubbles; the ait collects up top and can be expelled.
NOTICE
In case you don’t allow sufficient time for this your machine just will not
operate as it should. You can’te expel the air properly and you will end up
waiting some more!
-- The air is expelled by pumping it out. This is done by fully depressing the
exhaust pedal (10) followed by pumping action, some 15 to 20 strokes of the
lifting pedal (7)
-- Now try out operation without any load. Go to the highest point you can
reach and then let the lift down SLOWLY. The exhaust pedal is depressed
GENTLY so the lift comes down at its leisure.
WORKING PROCEDURE
WARNING
Please read and understand all warnings, notices and advice before you start
operating this lift. In case of non-compliance you are taking a risk of
accidents and injury. You will be responsible for the consequences!
-- The lift is to be put in a suitable place. You should check the surface
which must be horizontal and able to support the load. We advise you to put
the lift on a concrete surface.
-- You turn the adjusting bolt (30) down until the wheels (18) come off the
floor. Your lift is now entirely supported by its feet.
