EX23-R PoE Switch
1. Connect the 1-NTX003 power supply or 1-KAB2115 power
pigtail cable from the power connector on the EX23-R to a
10-36 V
DC
power source.
NOTE
Connect only the red and black wires of the 1-KAB2115 cable.
Do NOT use a 1-KAB2110 cable to power the EX23-R from the CX23-R.
Configuring the EX23-R
1. Connect a PC to any open port using a
1-KAB2106 cable.
2. Open an internet browser and navigate to:
o
IP Config: 192.0.2.1/ip_config.htm
o
Firmware: 192.0.2.1/upload.htm
3. Log on using the default credentials:
o
username:
admin
password:
(blank)
EX23-R Status LEDs
Power LED
Description
Off
Power input not in range
On
Unit is powered
Flashing (2 Hz)
Power error
Flashing (8 Hz)
Firmware update
Several issues can cause a power error:
o
Over temperature
o
Over voltage or over current input power
o
Internal power supply not working
Ethernet LED
Description
Off
No link
Green
Gigabit link is up
Orange
10 or 100 Mb link is up
2. Connect the desired devices to the Ethernet ports using
1-KAB2100, 1-KAB2106 or 1-KAB2107 Ethernet cables,
depending on the device.
CAUTION
Drawing PoE power lowers the maximum operating temperature. Please
refer to the data sheet for the exact de-rating specifications.
Setting up the EX23-R
The EX23-R is designed to be used straight out of the box.
NOTE
To reset to factory defaults, jumper port 1 to port 2 using
a 1-KAB2107 cable and power cycle the unit.
EX23-R Quick Start Guide
EX23-R Quick Start Guide
