Operating the Data Recorder
CX22B-R
A4722-1.0
HBM: public
31
6.2
Operation via a PC
In this case, the CX22B‒R Data Recorder is connected
to the PC via Ethernet. There are different variants, de
pending on your PC/network configuration, and the
procedure used to set up the connection depends on the
variant:
S
The CX22B‒R and PC are connected directly via an
Ethernet cable.
S
The CX22B‒R Data Recorder is connected to an Eth
ernet network (the network configuration is usually
assigned automatically via DHCP,
D
ynamic
H
ost
C
on
figuration
P
rotocol).
For a detailed description, see
.
S
The CX22B‒RW Data Recorder is connected via
WLAN (ad‐hoc to a PC or hotspot integration into lo
cal area network-LAN).
Important
Wait approx. 1 minute after switching on the CX22B‒R
before setting up a connection so that the boot process is
complete and the module is ready. Otherwise you may
receive an error message that the device could not be
found.
To make it easier to set up a connection when the
CX22B‒R settings are unknown, use the HBM program
HBM Device Manager
, which is part of the system soft
ware and included in the package as a DVD. It is also
available to download from www.hbm.com.