The first DAQ job with catman
EASY
CX22B-R
A4722-1.0
HBM: public
53
8
The first DAQ job with catman
EASY
Launch catman
EASY in the start screen
.
► Run a device scan
► Select the required devices.
8.1
Creating a DAQ job
A DAQ project contains all the settings for the devices,
transducers (sensors) and calculations used, how the
measurement is to be carried out, and which data should
be visualized online and saved.
Setting up DAQ channels
If you are not using transducers with TEDS (
T
ransducer
E
lectronic
D
ata
S
heet) assign the connected sensors
(transducers) to the channels: find your sensors in the
sensor list
Sensor database
component window), then
drag&drop each sensor to the channel to which it is con
nected. Set up your sensors in the sensor database, as
required.
Assign unique channel names
You can generate channel names with sequential
numbering or accept the sensor designation via the
Re
name
context menu. In catman
EASY, each channel is
identified by its name, so you must use meaningful
names where possible.
► Mark the channels to be set to zero and run a zero
balance (
zero balance
,
group
zero balance
).
