User's Guide
Modem Connection
The telephone wire used to connect the Notebook PC's internal modem should have either two or four
wires (only two wires (telephone line#1) is used by the modem) and should have an RJ-11 connector on
both ends. Connect one end to the modem port and the other end to analog telephone wall socket (the
ones found in residential buildings). Once the driver is setup, the modem is ready to use.
Note:
When you are connected to an online service, do not place the Notebook PC in suspend (or sleep mode)or else
you will disconnect the modem connections.
Warning :
Only use analog telephone outlets. The built-in modem does not support the voltage used in digital phone
systems. Do not connect the RJ-11 to digital phone systems found in many commercial buildings or else damage
will occur!
Caution :
For electrical safety concerns, only use telephone cables rated 26AWG or higher.
Using the Notebook PC
4-11
Using the Notebook PC
Summary of Contents for Notebook PC
Page 1: ...Notebook PC User s Guide ...
Page 2: ......