Roadstar Installation Instruction Manual
Page 3 of 8
Opening device and inserting SIM card
To ensuret that
Roadstar
will work within system for tracking vehicles
www.tracking.rs
it is neccessary
to provide unlocked SIM card with GPRS traffic provided (depends on chosen mobile operator).
Following pictures shows how to open device and insert SIM card into it.
First remove 4 screws as shown in picture on the left side. Genltly pull out board and place SIM card
into place shown in picture on the rigth side.
Picture 1 – Placing SIM card
When finished, place board back to the housing and put back removed screws.
NOTE:
Software on
Roadstar
automaticaly sets parameters for GPRS for most SIM cards of different
mobile operators. In case you need to set different parameters, check document
Roadstar
Configuration Manual
for details.
Placing antenna
Next step in installation is placing antenna.
Roadstar
has two connectors for anntenas: one for GSM
signal and other one for GPS signal. Antenna provided with modem has both connectors, for GSM and
GPS, and is easily mounted to modem. Both, antenna and modem have specified which connector is
for which signal (written on modem and cables) – GSM of antenna into GSM of device, GPS of antenna
into GPS of device.
