Place the tray table on the front of the armrests, then push it in until it clicks in place on
the mounting pins. It may be that just one side clicks in place, as the mounting pins are
not yet tightened. Push the other mounting pin into the fitting if necessary.
Grasp the tray table on both sides and push it (together with the mounting pins) to the
desired position. Tighten the nut on each mounting pin.
To remove the tray table grasp
around both sides and push the
locking levers up, then pull the
tray table straight out.
When the tray table is not in
place the mounting pins should
be turned in to avoid being in
the way.
Use and Care instructions
The tray table can be wiped clean with mild cleaner and water. Always replace damaged parts
immediately. For more information see
Maintenance Instructions
, document number 96730-1.
- When using a tray table there is a risk of pinching when the back is raised from a reclined
position. Be aware of this.
- The tray table is not intended for heavy loads.
- Restrictions might exist regarding the use of a tray table if it interferes with the user getting
out of the wheelchair. Be aware of regulations.
- Do not sit on the tray table.
-The tray table is set up according to the width of the wheelchair. When changing the
seating width the fittings on the tray table must also be adjusted.
.
Page 2 (2)
User manual/Assembly instructions - Tray table
4
5
6
7
4
6
7
5
