2 of 4
A
SSEMBLY
Carefully remove the contents from the carton and keep the carton for future storage. Be sure to untangle any wires
that may be tangled with other items. (Please DO NOT forcibly remove any contents.)
Step 1:
Locate the Tree Stand.
Assemble it by separating the legs of the stand to form an
“X” shape (
see
Fig. A
). Once you have the holes lined up, insert each of the eye bolts into
the holes on the stand’s middle section, being sure that the eye bolts do not extend so far
as to interfere with the installation of the tree pole. Place the stand or pot where you are
going to set up the tree – ensure that it is on a level surface and near a dedicated power
source.
THIS PRODUCT IS SUITABLE FOR INDOOR USE ONLY.
Step 2:
Locate the Tree Bottom Section “A” which is tagged with the letter “A”. Remove
any plastic protective pole caps that are on the bottom of the pole (they can be saved and
reused for storage if desired). Insert Tree Section “A” into the Tree Stand. Do not force the
pole into the Tree Stand. It will slide down to its correct position. Make sure the pole is firmly seated and standing
straight in the Tree Stand. Turn all the eye bolts until contact is made with the pole. If Tree Section “A” is not sitting
straight, then simply loosen the eye bolts, adjust the tree pole, and retighten the eye bolts.
Step 3:
Locate Tree Top Section “B” which is tagged with the letter “B”. Insert it into the top of Tree Section “A”.
Step 4:
Connect the light set plug from each tree section into the section below securely. The light sets each have a
plug with a male and/or female end with “Please plug in here” tags, so that you can find the corresponding connection
easier. Once all the light sets are connected in the tree, locate the male power plug and insert it into a 120-volt power
outlet in your home or into a UL approved extension cord or power strip (not included). The tree should now be lit. If
some bulbs do not light, please go to the
TROUBLESHOOTING GUIDE FOR LIGHT SETS
for steps.
S
HAPING
1.
Plug in the lights as you are shaping the tree. It is easier to see how the tree looks.
2.
Remove any packing strap or other packing material that is around the tree section(s) and allow the branches to fall
into place.
3.
Shape by section and layer, starting at the bottom of the tree and working your way up to ensure all branches are
shaped.
4.
Slowly pull down each branch to an approximate 90° angle to the floor on the lower sections and about a 45° angle
on the upper sections. While doing so, shape the tips on each individual branch by fanning out the tips to fill any
spaces. Offset the branches from one another to hide the tree’s pole and fill spaces. Continue spreading the tips
until they resemble that of a real tree.
5.
After shaping the whole tree, step back and take an overall look. Shift branches to fill any gaps. Your tree is now
ready to decorate and enjoy!
C
LEANING
&
C
ARE
As you will be using the artificial Christmas tree every year, it is essential to keep it in good condition and clean.
Dust gently using a soft cloth or fabric duster.
Do NOT use any chemicals or solvents to clean.
Handle the light sets gently. Do NOT pull or tug light sets as this may inadvertently loosen the bulb.
Follow all Storage and Safety Instructions.
S
TORAGE
1.
Unplug the tree from the power source.
2.
Remove any ornaments and decorations that were added by you and did not come with the tree.
Fig. A
