Help is only an email away:
support@hdanywhere.com
.
20
Setup on uControl (standalone or stack)
Before starting setup on uControl, ensure that your MHUB is wired up correctly, is turned on and is connected to the same router as your phone or tablet. If it is not, then
please refer to pages 15 & 17 and follow the steps there. You can not proceed with setup if you do not have uControl installed on your mobile device.
Completing setup in uControl will teach the MHUB what inputs are connected to it and where the outputs are located throughout your property (zones). Additionally, it will
grant you access to MHUB-OS for advanced management of your MHUB and, should you wish, connect the MHUB to HDANYWHERE’s online services (HDA Cloud) to register
your unit, extend your warranty, connect to the uControl service, enable voice control and remote monitoring or management. uControl setup should not take longer than
15 minutes to complete.
Start setup with uControl (Part 1)
1
. Load up uControl. You will be presented with an intro screen which will automatically disappear or can be swiped away.
2
. You will now see the home screen. This screen is only visible when no MHUB system is paired with uControl.
3. There are two options “Connect to MHUB” and an advanced management/tool option called “Manually Connect”. Select “Connect to MHUB”.
4. uControl will now perform a scan of your network and will find all active MHUB systems.
5. If there are any problems detected in the scan then they will be displayed in uControl here. The messages are dependent on what is detected:
Software Update Required:
uControl has detected that one or more MHUB requires an update to proceed. Remedy: update all MHUB’s in your network.
Software Mismatch:
the software found on one or more MHUB systems do not match Remedy: update all MHUB’s in your network.
MHUB’s is still in Stack:
uControl has detected that one or more MHUB systems are still in stack mode. Remedy: reset the MHUB in question back to factory settings.
6. If there are no errors then uControl will present you with the following options:
1) if a standalone MHUB is found then uControl will proceed to configure that system directly. (Jump to step 8)
2) if multiple MHUB’s are found then uControl will ask if you want to stack those systems (if supported) or connect to one of them individually.
7. If MHUB is being setup in Stack mode then you will be asked to nominate a Master and Slave device(s). Tip: identify the MHUB easily by clicking on the magnifying glass
icon to put that MHUB in to identification mode.
8. uControl will then contact your system to start the configuration process.
9. You will now be redirected to MHUB-OS, the operating system on board MHUB, to complete the setup process (see next page).
Summary of Contents for MHUB
