AUDI O
MHUB
9
3
4
1
2
1.
HDANYWHERE logo
: Indicator light. If this light is on and solid then MHUB AUDIO has power and is on.
2.
MHUB AUDIO logo:
Indicator light. If this light is on and solid then MHUB AUDIO has power and is on. If the light is flashing then MHUB AUDIO is in detection mode.
3.
Input (1-4)
: Input level presence indicator light. This light has 4 modes (Off/Flashing/Solid/Red): Off, Flashing & Solid are all OK for normal operation. Depending on the
input level this will determine the behaviour of the light. If the light is Red then the input is being overloaded and it’s recommended that you adjust the level down.
Solid light:
-19.5dB
Red light (overload):
+4.6dB
4.
Output Meter (A-D)
: Amplifier power indicator. There are four thresholds indicated by different colours. Green, Yellow and Red.
Green light on:
-20dB
Yellow light on:
-14dB
Red light on:
-10dB
All lights on:
0dB
If all lights are on then MHUB AUDIO’s amplifiers are operating at full power. HDANYWHERE does not recommend that you operate MHUB AUDIO at this level as this can
damage the life expectancy of your system and will negatively affect the audio quality (distortion and clipping). Levels and gain can be managed from within MHUB-OS
(see page 24-25). When MHUB AUDIO is setup correctly these lights should operate within the Green and Yellow ranges with occasional peaking in to the Red being OK.
Depending on your devices/settings you may not see the lights operate at all. This is also OK.
Front panel: MHUB AUDIO (6x4)
Summary of Contents for MHUB
