6
HARDWARE INSTALLATION
1. Connect a HDMI or DVI source (such as a Blu-ray Disc player) to the transmitting unit HDMI-C5S4IR-TX.
2. Connect a HDMI or DVI display (such as a LCD TV) to the receiving unit HDMI-C5S4IR-RX.
3. Connect IR Blaster/Receiver to both TX and RX units.
4. Connect a Cat-5/5e/6 cable between the transmitting and receiving units.
5. Make sure this Cat-5/5e/6 cable is tightly connected and not loose.
6. Plug in 5V DC power supply unit to the power jack of the receiving unit HDMI-C5S4IR-RX.
7. Plug in 5V DC power supply unit to the power jack of the transmitting unit HDMI-C5S4IR-TX.
8. If you see flickering or blinking image on the display, please adjust the rotary control switch to improve the cable
skew. 0 stands for the strongest HDMI signal level for longest possible transmission length while 7 stands for
the weakest HDMI signal level for short transmission length. Please adjust the signal level from 7 to 0 and stop
turning the rotary switch whenever the audio/video is playing normally. Inappropriate signal level setting may
cause overpowering issue that would shorten the product life significantly!
EDID LEARNING
1. Turn off HDMI-C5S4IR-TX and disconnect the Cat.5/5e/6 between HDMI-C5S4IR-TX and HDMI-C5S4IR-RX.
2. Connect the HDMI display to "
HDMI IN
" on the HDMI-C5S4IR-TX with a HDMI cable.
3. Set "
MODE
" on the transmitting unit HDMI-C5S4IR-TX at
H
.
4. Turn on the HDMI-C5S4IR-TX.
5. The LED on the RJ45 of HDMI-C5S4IR-TX will dim and light again, which indicates the EDID learning procedure is
complete.
6. Unplug the HDMI cable from the display and follow the instruction in [Hardware Installation] to set up the
HDMI-C5S4IR and enjoy the experience.
