Disclaimer:
Viewing in 3D mode may cause disorientation for some viewers. DO NOT place your HDTV
near open stairwells, cables, balconies or other objects that may cause you to injure yourself.
6
HDfury 3D Glasses and Emitter – User Manual
Adjust 3D Glasses Duty Cycle/Invert
To adjust the Duty Cycle quick press the Bottom Button (DO NOT HOLD) to cycle through 16 presets to
pick the preset with the least amount of ghosting and crosstalk. To adjust L/R, L/L, or R/R modes for
PlayStation SimulView
TM
mode press and hold the Bottom Button for 1 or 2 seconds then release and
the led will flash 1 (L/R) time, 2 times (L/L), 3 times (R/R) to let you know which mode you are in. Please
note that the glasses will autosave all settings after you make an adjustment.
Pair 3D Glasses to HDfury4 emitter
To Pair the glasses to the emitter or add additional glasses please follow these simple steps. Do one pair
at a time. And make sure emitter is connected to the hdfury 4 and is powered up.
1. Power up the glasses by pressing and holding the Top Button for over 1 or 2 seconds.
2. Press the Bottom and Top Button on the glasses and hold and you will see led starting flashing
(once you see led flashing you can release both buttons).
3.Press the emitter Pair button (On the HDfury emitter than you will see the glasses emitter flash 2
times than power off meaning the pairing is complete).
4. Repeat this for each pair of glasses you own.
5. Press emitter pair button (On the HDfury emitter) to exit Pair mode.
Reset Emitter to Factory Defaults
If you need to reset the emitter back to factory defaults press and hold the reset button for 3 seconds
and it will be reset.
Reset 3D Glasses to Factory Defaults
If you want to set your 3D glasses back to factory defaults press and hold the Top Button to turn the
glasses ON. While the glasses are ON Press the Bottom and Top button on the glasses and hold till you
will see the led starting to flash then release do this again and the glasses will flash its led twice to let
you know it has been set to factory defaults.
