Disclaimer:
3
rd
party and/or custom firmware providing extra features are not covered in this manual.
34
4K Diva – User Manual
[RS232 COMMAND]:
Allow you to test RS232 command to make sure your unit is properly configured
and ready to communicate via RS232.
[RS232 BAUD RATE]:
Set the RS232 link speed (default 19200)
[Send Ascii]:
Once RS232 command have been entered in Ascii format, use this button to send it out.
[Send Binary]:
Once RS232 command have been entered in HEX/Binary, use this button to send it out.
[REFRESH]
: Refresh the current page.
Note:
CEC/ARC master is TX0, if you want ARC from the TV; you need to connect your TV ARC capable
input to Diva HDMI TX0 OUTPUT and set the unit as Audio Processor under Diva CEC device type.
Note on eARC
: eARC does not rely on CEC, therefor it is not needed to select any CEC options in order to
extract up to Dolby Atmos HBR over TrueHD from capable eARC TV. That is always done automatically
and forwarded to HDMI audio out of the Diva so you can feed any AVR input with it.
