Disclaimer:
3
rd
party and/or custom firmware providing extra features are not covered in this manual.
37
4K Diva – User Manual
[PROFILE]
:
Select the tone-mapping profile that works best for your display here. Most users should get
best results using Profile 2; however some display might render better colors using slightly different
profile.
[ACTIVE VIDEO]:
Select the LEDstrip light effect that must be applied when there is active video. Default
is FOLLOW ACTIVE VIDEO but you might want to turn it OFF or select another effect from there at some
point. Ex: Audio effect is underway for a future firmware update; you will be able to switch from Video
effect to Audio effect here.
[WHILE SYNCING]:
Select the LEDstrip light effect that will be applied when there is no active video. If
Sinks or sources are turned off, you can define a different LEDstrip effect here.
[NEVER TURN OFF]:
If you want to keep a LEDstrip effect running forever even when there is no active
video or when sources and/or sinks are turned off, you can enable it via this option.
[VIDEO GAMMA]:
For some profiles combinations or depending on the wall color, you might want to
slightly alter gamma value to render better colors via LEDstrip. (Default value is 2.2)
[PULSATING SPEED]:
Define the speed of the Pulsating LEDstrip light effect.
[ROTATING SPEED]:
Define the speed of the Rotating LEDstrip light effect.
[STATING COLOR SELECTION]:
Define the color of your choice for the STATIC COLOR LEDstrip light
effect. R/G/B color values range from 0 to 255.
[LED ELEMENT GLOBAL COLOR CALIBRATION]:
Boost or reduce R/G/B intensity for all LEDs. RGB
intensity values range from 0 to 31
[ACTIVATE LAG TEST]:
Turn ON or OFF the LAG Tester mode. Once activated, you should see the
squared window on active video from TX1 where the LAG Tester light sensor must be placed.
[TARGET]:
Select where on the screen the input LAG test window should be located (Left Top, Center,
Right Bottom)
[START TEST]:
Once LAG tester light sensor is correctly placed on the squared window that appears on
screen, click here to start measurement, results are reported on top left corner via OSD (On Screen
Display). Accuracy in milliseconds is up to 1 decimal.
[ENABLE]:
Once configured with dropdown field and enabled, this option will display a test pattern at
TX0 output. It can be useful for testing equipment. 480p60, 720p60; 1080p60, 4k24 or 4K60 resolution
are available, Pattern can be color bars, ramp1 or ramp2 and HDCP can be set to none, 1.4 or 2.2
.
[REFRESH]
: Refresh the current page.
