Disclaimer:
3
rd
party and/or custom firmware providing extra features are not covered in this manual.
15
4K Diva – User Manual
Help on LAG Tester installation
1.
Connect LAG tester to IR Sensor input (p.12)
2.
Enable LAG test mode via webserver
3.
Stick the LAG tester on the video boxed area.
START THE TEST AND WAIT OSD RESULTS
Note
: LAG Tester cable can be extended using any
earphone 2.5mm jack extender
You can choose 3 different on screen locations to place
the LAG tester sensor and perform measurements.
Results are accurate up to 1 decimal.
If you need more help, you can refer to the below video:
Diva LAG Test Video on YouTube
LAG TEST works using TX1 output ONLY.
In order to test a display input lag for 4K HDR signal, you need to connect TX1 output back to a Diva input and route that Input to TX0
Diva scaling parameters should be set to default
[Webserver > Scaling > AUTOSCALING Enabled]
.
AUTOSCALING Presets should be set to default one as well
[AUTOSENSE selected and UPSCALING Enabled]
.
HDR > SDR Conversion for TX0 output should be disabled.
[Webserver > Tools > Profile 0-OFF]