Disclaimer:
3
rd
party and/or custom firmware providing extra features are not covered in this manual.
33
4K Vertex – User Manual
persistent over hotplugs and power cycles. This way customer can for example activate BT2020 mode in
the TV even though content doesn't sent the correct InfoFrame. The AVI mod is really meant for
advanced users only because incorrect values can blank the screen and since the settings are saved even
power up won't help until reset.
[CAPTURED VENDOR SPECIFIC INFOFRAME]:
If the source is sending Vendor Specific Infoframe then the
information is captured, extracted and displayed in this text box on GUI.
[CUSTOM VENDOR SPECIFIC INFOFRAME]:
Enter the Vendor Specific Infoframe of your choice in this
text field in HEX format. If you are not sure about how to format your AVI Infoframe, we recommend
you to visit our
Infoframe Injection thread
in our support forum. (Advanced Users only)
[Send VSI]:
Replaces the current incoming VSI with the custom defined one in the text box. This string is
also saved in Vertex and is persistent over hotplugs and power cycles. Please note that upon clicking,
Enable Custom VSI
will get activated automatically, to stop the sending of the custom VSI infoframe,
uncheck
Enable Custom VSI.
If
Enable Custom VSI
is activated then by pressing the
Send VSI
button, the
infoframe injection does not stop, it just changes values.
[Disable VSI]:
When checked, Disable VSI will prevent DSI InfoFrame from source to reach the
connected sink at Vertex output and also stop sending Custom VSI if set previously.
[Enable Custom VSI]
: Upon clicking
Enable Custom VSI
, the IF that is defined in the Custom VSI text box
gets used. This way you can define what the InfoFrame actually is. This is stored also in Vertex and is
persistent over hotplugs and power cycles.
Note
: There are two ways to reset the strings. Either hold the RESET button 10 seconds on Vertex or go
to the GUI "config" page and apply reset. After GUI reset close and reopen GUI. Then the fields are
populated with reset values.
Public API/DLL
: We have created a set of DLL/API package for Vertex so anyone can interface their
Windows software with Vertex capabilities and build evaluation, testing, measurement, calibration and
content creation workflows system.
IR/RS232:
Vertex can be fully controlled via IR or from any serial based computer such as Win, Max or
Linux using RS232 interface. Complete list of IR and RS232 commands are included as a text file for
convenience on all Firmware updater and GUI utility package.
