Disclaimer:
3
rd
party and/or custom firmware providing extra features are not covered in this manual.
36
4K Vertex² – User Manual
[AUTOSWITCH INPUTS]
:
When activated, the new TMDS / Pixel clock Auto switch feature will force the
Vertex² unit to automatically switch to the active signal if the selected signal is lost. It can also auto
switch source that keep s5V when in standby such as ATV4K, X1X, Shield and others.
[AUTOSWITCH PRIORITY]
: When input priority mode is enabled, as soon as a new active input is
detected, Vertex² will switch to it.
[HDCP VERSION]
:
Allow you to select/force the HDCP revision of the TX1 Output Port.
[HTPC MODE]:
Useful if you have trouble with windows display and icons when resuming from stand-by
mode. Please note that with default firmware HTPC mode is not compatible with HDCP signal. You can
set HTPC mode for each input individually.
[OLED DISPLAY]:
Enabled by default
,
Vertex² OLED display can be turned ON/OFF at will. Some users
might found the Vertex² OLED display visually disturbing in their HT setup. You have the possibility to
turn it off.
[ROTATE 180 DEG]:
OFF by default, based on your setup, you might prefer to flip the OLED display, once
activated, this option will flip the Vertex² OLED.
[REVERSE COLORS]:
OFF by default, once activated this option will reverse the Vertex² OLED colors.
[OLED FADE]:
Allow you to define a custom timing in seconds before OLED FADE, set it to 0 for OLED to
always stay active. Default is 30sec.
[OLED PAGE]:
Select the OLED page that will be displayed at startup
.
[MUTE TX0 AUDIO]:
If you use an AVR at HDMI audio out, you might want to disable sound going to
equipment connected at TX0 output. Here you can mute the TX0 output sound.
[MUTE TX1 AUDIO]:
If you use an AVR at HDMI audio out, you might want to disable sound going to
equipment connected at TX1 output. Here you can mute the TX1 output sound.
[IR]:
You can globally turn ON or OFF IR support for Vertex²
[ANALOG L/R AUDIO CONTROL]:
This option will adjust the Analog Stereo output from this section.
Volume, Bass and Treble control are available.
[SEND]:
After Volume, Bass or Treble values changes, click send to apply your changes.
[TEST PATTERN GENERATOR FOR TX0]
: Once configured with dropdown field and enabled, this option
will display a test pattern at TX0 output. It can be useful for testing equipment. 480p60, 720p60;
1080p60, 4k24 or 4K60 resolution are available, Pattern can be color bars, ramp1 or ramp2 and HDCP
can be set to none, 1.4 or 2.2
[IP CONFIG]:
This section allows you to edit the way Vertex² will retrieve its IP address. Any changes will
only be applied after reboot (power cycle)
