2 Safety notes – Intended use
8
2 Safety notes
2.1 Intended use
B
ASIC
SYSTEM
DESIGN
PRINCIPLES
B
ASIC
PRINCIPLES
The heating system was built using state-of-the-art technology and
conforms to recognised safety regulations. Nevertheless, there is still
a risk of injury or death to users or bystanders, and of adverse effects
upon the heating system or upon other material goods.
Have your
specialist heating company provide you with detailed
instructions on the operation of the heating system
.
U
SING
THE
HEATING
SYSTEM
Only use the heating system when it is in perfect condition. Use it
properly, as intended, be aware of safety and hazards, and observe
the Operating manual. Have any faults which could impair safety
fixed immediately.
This device can be used by children over 8 years old and people with
reduced physical, sensory or mental capabilities or a lack of
experience and knowledge, provided they are supervised or have
been instructed on the safe use of the device and understand the
resulting risks. Children may not play with the device. Cleaning and
user maintenance must not be carried out by children without
supervision.
B
ASIC
PRINCIPLES
FOR
THE
CONTENT
OF
THE
OPERATING
MANUAL
S
COPE
The content of this operating manual is intended exclusively for the
planning, installation and operation of the HDG Euro 30/40/45/50
boiler. The further implementation of applicable standards and
guidelines, for example regarding installation of the heating system
(pipework, etc.), is not part of this operating manual. HDG does not
assume any liability for this.
P
ROPER
AND
IMPROPER
OPERATION
P
URPOSE
OF
THE
HEATING
SYSTEM
The HDG Euro 30/40/45/50 boiler is designed for the standard use of
burning untreated wood, for example in the form of split logs,
pressed wood briquettes and chippings, in water heating systems.
Any other application is considered improper use. The manufacturer
will accept no liability for any damage resulting from improper use.
The operator bears sole responsibility in such cases.
Proper use includes adherence to the installation, operation and
maintenance requirements specified by the manufacturer.
