Page
13
of
34
Install the copper base plate, with rack attached, to the motherboard. Confirm
that heat pipe slot direction is vertical to the side panel. Tighten the four M3*30
Round Head Screws
H-3
in an even fashion. We recommend you stop tightening
the screws when the M3 threads have just fully emerged within the bottom
holder
（
H-6 or H-7
）
. Do NOT over tighten the
H-3
screws, and avoid putting too
much pressure on the CPU.
Apply a very thin layer of thermal paste to the heat pipe grooves on left panel
and the copper plate grooves using the dumbbell shaped tool provided
Warning: Do not over apply thermal paste, as it will decrease heat transfer efficiency.
