Page
19
of
34
If an HDPLEX 160W AC-DC is installed on the left side, install four 50mm copper
posts
G
to the H5 base plate, surrounding the AC-DC. An HDD rack with two SSD
on the bottom, and one 3.5”HDD on the top can then be secured to the 50mm
posts
G
using four M3*5 Round Head Screws
A
.
If no PSU is installed on the left side, two HDD racks may be installed using
40mm, then 30mm copper posts
G
. This arrangement may be implemented on
any of the three HDD mounting points, if the spot is unobstructed.
If you plan to install 5.25” device such as 5.25 optical drive or hot swap HDD
cage on to the right side, there are two options:
A
: If a 250W HiFi DC-ATX has been installed on the right side, install four 40mm
copper posts
G
to the H5 base plate, surrounding the DC-ATX. Secure the 5.25”
device to two 5.25” racks using eight M3*8 screws (these screws should comes
with the optical drive), and then directly attached the two 5.25” racks to the
40mm copper posts
G
using 4pcs
A
.
.
