1
www.observint.com
HDV_R8VTPS_CQ
190630
Drop cable
Slot in mounting plate
for trim ring tab (3)
Mounting plate
Trim ring
Trim ring tab (3)
Mounting side of mounting plate
12 Vdc Power connector
Cables labeled for function
Terminal functions
Reset button*
Ethernet
connector
(with PoE)
*
To reset the camera, press and hold down the Reset button for ten seconds while the camera is powering on.
Camera drop cables
What’s in the box
•
Camera assembly
•
Waterproof Ethernet connector
•
Mounting hardware
•
Security L-wrench
•
Drill template
•
Quick Installation Guide
Tools you need
To install the camera, you will need:
•
12 Vdc power source or Ethernet PoE injector. See
Specifications
for wattage requirement.
•
Tools and additional fasteners (may be required) for mounting the camera
•
Phillips #2 screwdriver
•
Ethernet drop cable
•
12 Vdc power extension cable (if powering with 12 Vdc supply)
Installation
Before installation:
•
Make sure that the device is in good condition and all the assembly parts are included.
•
Check the specification of the products for the installation environment.
•
Make sure that the wall or the ceiling is strong enough to withstand 3 times the weight of the camera.
R8VTPS 8 MP IP Varifocal 150 ft IR
Turret Camera Quick Installation Guide
This 8.0 MP IP turret security camera captures sharp high definition video images with its 8 MP high-
performance CMOS sensor and 3.3 ~ 12 mm motorized varifocal lens. This cameras features:
•
3840 (H) × 2160 (V) (8 MP) progressive scan STARVIS CMOS sensor
•
H.265 / H.264 video compression
•
3.3 mm ~ 12 mm motorized varifocal lens providing a 105 ~ 37° horizontal field of view
•
Full-frame IR up to 150 feet
•
Flip and Rotation image adjustments
•
3D-DNR, True WDR, IR cut filter
•
IP66 weatherproof rating
Turret
Enclosure
Trim ring
Light
sensor
Lens
R8VTPS camera assembly
Holes for
mounting
screws (3)
Tabs (2) hold
enclosure
Clip plate
and screw
Camera (turret assembly without trim ring) top view
