HeadHunter X-CALIBER XR-124, Installation And Operation Manual

Doc No. XG-0042   Rev No. 042808

4

Mounting the X-Caliber: 

Install the four rubber vibration isolation mounts provided into the four mounting holes of the foot of the X-Caliber   
bracket. 
 
Secure the pump to the foundation by installing the appropriate fasteners through the rubber vibration isolation 
mounts. 
 
Mount pump to foundation so that control panel is visible and accessible. 
 
An innovative rotating mounting bracket allows the pump to be mounted in a wide variety of configurations. If the 
pump is to be mounted on a horizontal plane, there is no need to rotate the bracket. To mount the pump to a 
vertical wall or angled plane; loosen the top bracket by removing the four mounting screws, remove the top half of 
the bracket, and rotate the cylindrical pump body within the mounting bracket to the horizontal, vertical, or even 
angled planes. A unique interlocking mechanism within the mounting bracket will secure the pump body to prevent 
any movement within the two halves of the bracket. Once the pump is in position, secure the top bracket to the 
lower bracket with the four screws. 

If the pump is installed in the vertical position, put the inlet at the bottom and the discharge of the pump at 
the top. If the pump is installed on a horizontal or angled plane, align the inlet and discharge as close to the 12’ o 
clock position as possible

.