10
Hardware Assign
The Hardware Assign screen enables you to customize how
HeadRush Gigboard’s footswitches and an expression pedal
control each rig.
To open the Hardware Assign screen
, tap the
button in
the upper-right corner of the main screen, and then tap
Hardware Assign
.
To return to the main screen
, tap the
button in the upper-
left corner.
Important
: The Hardware Assign settings are all part of the
overall rig, so remember to save your changes you want to
keep.
To set the color associated with the rig
, tap it in the upper-left part of the screen. This color will appear next to
the rig name when you view a list of all available rigs or when you view and create setlists. It will also be the color
of the corresponding footswitch indicator when HeadRush Gigboard is in Rig View.
To set the tempo of the rig’s time-based effects
(delays, modulation, etc.), tap the button under
Tempo
to
select
Current
or
Fixed
.
•
Current
: The rig will use the last-used tempo or the one set by the
Tempo
footswitch.
To set the tempo
, press the
Tempo
footswitch at the desired tempo 3–8 times to set the new tempo in beats
per minute (
BPM
).
•
Fixed
: The rig will use a tempo that you set here.
To set the tempo
, turn the
encoder
to set the desired tempo in beats per minute (
BPM
). You can set the
tempo only in this Hardware Assign screen.
To load a rig when a MIDI program change is received from an optional external MIDI device
, or
to send a
MIDI program change message when a rig is loaded,
tap the button under
MIDI
, and then turn the
encoder
to
select a MIDI program change number. You can adjust whether MIDI program changes are received and/or sent
in the
Global Settings
menu.
Note:
If a rig is using a number, that number will be unavailable and cannot be assigned to another rig.
Additionally, saving a rig with a new name will save the rig but without the program change number to prevent
rigs from sharing the same number.
Footswitches
The 4 boxes in the lower-left corner represent the 4 footswitches of HeadRush Gigboard. You can assign any
switch-based parameters (ones with only two states) to any of the footswitches—regardless of their location in
the signal chain.
To assign a parameter to a footswitch
:
1.
Tap a box.
indicates an empty box.
2.
In the list that appears, tap the model with the parameter
you want to assign.
3.
In the list that appears, tap the parameter you want to
assign. Usually, the parameter will simply be
On
(to activate
or deactivate it).
Tap
Unassigned
to unassign that footswitch.
To swap two assignments
, tap and drag one of them over the
other, and then release it.
Summary of Contents for Gigboard
Page 88: ...Manual Version 1 0 ...
