CHARGING THE DEVICE
1.
Connect the charging cable to GoBe3: Carefully pull out the charging socket plug located
on the band’s rear side, find the logo on the cable and turn it towards the sensors, then insert
the cable until it stops;
2.
Connect the charging cable to a USB port on your PC or mains adapter and turn on the
power source;
3.
Wait until the GoBe3 display shows the screen with a notification that the charging
process has started;
4.
Leave GoBe3 connected to the power source until the display shows the screen with a
message that the battery is completely charged;
5.
Unplug the charging cable from the power source and then unplug it from the band;
6.
Close the charging socket plug on the rear side of the band;
7.
GoBe3 is ready to work. You can start using it.
ADVICE ON CHARGING THE DEVICE
Before charging GoBe3, make sure that the contacts on the band and charging cable are
clean and dry.
You can set your band’s charging schedule at your own convenience. GoBe3’s charge cycle
should be done once a day for two hours or two times a day for an hour each.
You can always buy a charging cable on our website:
healbe.com/store
.
We recommend charging your GoBe3 in the morning after waking up and before breakfast,
for a good opportunity to wear the band at least 30 minutes before your first meal. In this
case, the estimated calorie level will be the most accurate.
We recommend manipulating the power socket plug carefully. If the plug is broken or lost,
the device may malfunction and the charging process may fail.
GoBe3 SYNCHRONIZATION
WITH HEALBE MOBILE APPLICATION
The GoBe3 performs measurements and stores the results throughout the entire time of
wearing, even if it is not connected to the HEALBE application on your smartphone. When
12
13
Data synchronization starts automatically when the app opens.
While the device syncs, make sure both the mobile phone and the band are no further than
35 inches (90 cm) apart to provide a stable connection.
Synchronize your GoBe3 with the HEALBE app at least two to three times a day. By doing so,
all the data will be saved and the sync will take less time.
If GoBe3 hasn’t synced with the app for several days, the next synchronization will take more
time than usual.
Warning! GoBe3 keeps unsynchronized data for five days.
Data stored on the band for more than five days will begin to be erased if you connect the
GoBe3 to the application less often than every five days.
This only happens if you do not synchronize and continue wearing the band.
If you have problems syncing your device, please contact the HEALBE client support service
by sending an email to
gobe@healbe.com
.
SKIN SENSITIVITY
We do not recommend applying moisturizing creams, cosmetics, or oils to the skin under
the sensors.
After working out or spending time in water, wipe and dry the rear surface of the band that
comes in contact with the skin, as well as your wrist, to avoid irritation from accumulated
moisture.
We do not recommend wearing the band if the skin zone under the sensor is marked by
tattoos, scars, inflammatory changes, or other severe skin surface damage. All of these
factors may lead to skin irritation or allergic reactions.
Skin irritation may also be caused by an allergic reaction to the band’s materials. A full list of
materials in contact with the skin can be found on our website under the “Materials,
Contraindications & Allergies” section (
healbe.com/manual-gobe3
).
the band is connected to the app, it synchronizes, which means the data are being
transferred from the band to the phone.
Summary of Contents for GoBe3
Page 1: ... SMART BAND ...
