9. Infra Red Command Repeater Connection and Operation
IR BLASTER (IR Out)
Plug IR Blaster 3.5mm plug into the IR Out port of Transmitter unit.
Place the IR Blaster in front of the source device's IR receiver, usually
in the front panel.
IR RECEIVER (IR In)
Plug IR Receiver 3.5mm plug into the IR In port of Receiver unit.
Place IR Receiver at or near the remote display, so the front has the
clearest line of sight view of the area from which the remote control
might be used.
If the IR remote function is not responding, Ensure the IR Receiver
and Blaster are fully inserted into the correct IR jacks on the Extender
and Transmitter units, and are not reversed. Carefully place the IR
Receiver and IR Blaster for best operation.
Check there are no obstacles between your remote and IR
Receiver, or IR Blaster and device.
A smart phone camera can help by showing the IR blaster
output.
Ambient infrared light from windows or some lighting can
reduce IR remote control range, so it may be necessary to shield
the IR Receiver or position IR Blaster more carefully in
consideration.
©2017 online.laceys.tv
Summary of Contents for HDC6IRL
Page 6: ...7 Connection diagram ...