- 4 -
5.4. Resetting the unit
The Reset will clear the following data, and factory defaults will be restored:
- Gear Positions recorded
- TRE mode (default is Normal mode, i.e. TRE off)
- Auto Brightness Control Sensitivity Level (default is 4)
1.
Activate the display
(refer to section 5.1).
2.
Press the button and keep it depressed until “
L
” (Learning) appears on the display.
3.
Press and release the button again to terminate the Auto-Learning procedure.
“
U
” (Update) is blinking on a display for a few seconds. Factory default values have
been restored.
Note:
The unit retains all settings when the battery is disconnected or removed.
5.5. Checking whether pre-set (default) or custom (taught) Gear Positions are in use
Disconnect and reconnect the power lead on the battery terminal to restart the unit.
Whenever the unit is powered up, the display indicates either “
d
” (default) or the number of
gears taught (
5
) for about 1 second, then the actual gear selected will be shown.
5.6. Checking and Adjusting the Sensitivity of the Auto Brightness Controller
The sensitivity can be adjusted in 10 levels, from
0
to
9
.
Level
4
is the default value. Decrease the level if you’d prefer less brightness, and increase the
level if more brightness is desired.
If you decrease the Sensitivity Level in low ambient light, or increase it in strong daylight, you
may not notice a difference in display brightness because it may be already at minimum or
maximum setting.
If you set the level to
9
, the Auto Brightness Controller will be disabled and the brightness will
be always at maximum, regardless of the ambient light intensity.
1.
Select Neutral and have the ignition key in OFF position. The display is blank.
2.
Depress the button then turn the ignition ON.
3.
Release the button after about 3 seconds, when “
A
” (Adjust) is displayed.
4.
The current Sensitivity Level is shown on the display (blinking).
5.a. If you don’t want to change the Sensitivity Level, wait until the display stops blinking.
After 3 seconds, the display goes back to normal operation.
5.b. If you’d like to change the setting, press and release the button while the display is
blinking. You can cycle through the values by pressing the button repeatedly.
When the desired Sensitivity Level is blinking on the display, wait for three seconds.
The display goes back to normal operation, and the new Sensitivity Level will be in
effect.
5.7. Cleaning the display
The LED display is protected by a Plexiglas filter element. Wipe clean it with wet sponge.
To avoid scratching the filter, do not clean with dry cloth.
The unit is waterproof, however, do not spray high pressure water directly on the display.
