WSK-MLT will not adjust a 9 volt solenoid on the 6000TRXi or the Olympian.
*Only units with an adjustable regulator can accommodate the solenoid included with the WSK-MLT.
the WSK-MLT will not control a 9 volt solenoid.
Are there replacement parts available?
*The only replacement part available is the solenoid, all other components are not replaceable individually.
What does the Cold Climate button do?
*This allows the pilot flame to stay lit when activated, a benefit of this is reduced condensation on the glass
at start up in cold climates.
Can I change the color of the wall plate that is around the wall switch to match other outlet
in the room?
*Although others may fit, the cover plate included with the WSK-MLT is specially designed to
accommodate the thermostat function of the WSK-MLT. Changing the panel that is around the wall
will result in inaccurate temperatures
Can I used my WSK-MLT when the power is out?
*Yes! There is a manual switch on the side of the receiver, see figure 2. However, you will not be able to
use the LED control panel.
LED display temp is higher or lower then room, why?
*The LED control panel is installed on an exterior or non-insulated wall. The thermostat can read the wall
cavity space temperature, which can be hotter or colder then the actual room temperature.
*Although others may fit, the cover plate included with the WSK-MLT is specially designed to
accommodate the thermostat function of the WSK-MLT. Changing the panel around the wall switch
will result in inaccurate temperatures. Your LED wall panel must say Heat-N-Glo or Heatilator.
*LED control panel may take up to 30 minutes to stabilize after installation or power outage
Temperature is inconsistent, what could be the problem?
*The wall panel is installed on a exterior wall. The wall panel switch is taking a temperature of the
cold air space in the wall.
When in Thermostat mode, my fireplace doesn't turn on when that set temp on the wall
switch is reached?
*By design, there is a 1 to 3 temperature differential. The reason for this is to prevent the fireplace
from continually turning itself "on" and "off" while in thermostat mode.
Can the CABIN-KIT be used on the WSK-MLT?
*The CABIN-KIT cannot be used if also using the WSK-MLT. The WSK-MLT incorporates the features of the CABIN-KIT.
When I press the Cold Climate button, both the pilot and the burner turn on, what is the problem?
*Make sure the ON/OFF switch on the receiver is in the "OFF" position.
FAQ's
5