Remote Receiver Wiring Check
1. Verify to the related wiring diagram (IPI or Standing Pilot)
Valve Assembly Check (Standing Pilot Only)
Fig. 1
*Wall panel switch will not turn fireplace "ON" or "OFF"
1. Verify the gas control knob is in the "ON" position
(Fig. 1)
2. Verify the ON/OFF manual rocker switch is in the "OFF" position
A - If ON/OFF manual rocker is in the "ON" position, the WSK-MLT
ON/OFF function will be superceded by the manual switch
Remote Receiver Check
*Wall panel switch will not turn fireplace "ON" or "OFF"
Fig. 2
1. Verify Wiring is correct, see related wiring diagram
2. Verify that the battery bypass switch is in the "OFF" position
*The only time this switch should be turned "ON" is in the event of
a power failure, turn switch "OFF" when power returns
3. Verify continuity (batteries install) at the wires marked "3 Volts DC"
(IPI)
A - With receiver switch off, you should not have continuity.
4. Standing Pilot units only, verify thermopile is plus 200 mv with burner "on."
**Bypass WSK-MLT to do this test
Temperature Display
*Thermostat reading is higher or lower than actually room temp.
1. LED control panel may take up to 30 minutes to stabilize after installation
Fig. 3
or power outage.
1. When a button is pressed, the display will illumination. This illumination
can raise the temp shown on the display, normally 3 - 5 degrees
2. Verify that the panel cover plate says "Heat-N-Glo" See FAQ's
for explanation
Important
: If the
▲
or
▼
down arrows are pressed without pressing
the flame, fan, temp, set, or aux button, the display will stay lit for
approximately 15 minutes. This would result in a 10 to 20 degree increase.
*How do I manually calibrate the temperature displayed?
This is a very delicate procedure, the component is very fragile
1. Removed WSK-MLT control panel from the wall.
2. Located the small hole on the left side of control panel.
A. Insert small standard screw driver. The size need to be
small, similar to a eye glass repair screw driver
B. Note position of the screw to establish starting point.
C. Turn counter clockwise to lower, clockwise to raise temp
*Normally an 1/8 turn is more then enough
*Do not press down hard on the screw, or you will damage component
Remote Trouble Shooting Guide
Models: WSK- MLT
This should
only
be manually adjusted
when extreme temperature between actual
and LED read out exists.
1
