8
4. Set the Console Base (83) face down on a soft
surface to avoid scratching the Console Base.
Remove the two #8 x 3/4" Screws (6) from the
Console Frame (87). Remove the Console
Frame. Discard the Screws.
83
87
6
4
3. Hold the Left Upright (75) against the Base
(80).
Be careful not to pinch the wires.
Insert
a 3/8" x 4" Patch Bolt (4) with a 3/8" Star
Washer (5) into the top hole in the Left Upright.
Insert the 3/8" x 4" Patch Bolt (4) partially
through the Left Upright (75). Next, slide a Bolt
Spacer (93) onto the end of the Patch Bolt.
Then, tighten the Patch Bolt partially into the
Base (80).
Partially tighten two more 3/8" x 4" Patch Bolts
(4) with two 3/8" Star Washers (5);
do not fully
tighten the Patch Bolts yet.
Attach the Right Upright (not shown) in the
same way.
Note: There are no wires on the
right side.
75
93
3
5
5
4
80
Wires
