4
Wire Pinch Point
Assembly Instructions
STEP 1: Attaching the Seat Handles
Put the seat back support tube (70) in the upright position and lock the pop pin in
place. Connect the contact heart rate wire coming from bottom of the seat handle
set through the hole in the seat base frame to the wire coming from the bottom of
the seat back support tube (70) Attach the seat handle set (75) to seat base
frame using 4 bolts (32).
STEP 2: Assembling the Seat Back
Attach the seat back cushion (75) to the seat support tube (70) using the
4 screws that are already in place in the seat back cushion (32). Then
connect the pulse sensor wire (81) to the receiver (125). Place 3 AA
batteries in the battery pack (126).
Next attach the seat back cover (85) to the back (75) using the 6 screws
that are already in the seat back cushion (91).
Gently Test the Seat Recline Angle to Ensure the Pulse Wire Moves Freely
Note: If Heart Rate Measurement Appears Inaccurate
– Replace Batteries
Wire Pinch Point
Summary of Contents for CardioStep
Page 2: ......
Page 11: ...9 CardioStep Display Console...
Page 25: ...23 Exploded Diagram...
Page 28: ...26 Service Notes Date Service Performed Company Phone...
