25
7.Error message and debug:
E1: No speed detected.
。
(1) Check speed sensor, loosen or broken. Speed sensor should closer with
magnet in 2 to 3 mm.
(2) Check sensor connector attached to controller property.
E2: System Data lost
(1) Check EEROM loosen, replace EEPROM IC.
E6:Incline reverse
(1) Incline motor wire reverse,switched red/black wire.
(2) change the Incline motor.
E7: Incline out of the range
(1) Change the Incline moor.
(2) incline motor over heat, wait until motor recovered.
(3) Check incline motor connection.
(4) incline motor stuck, change the motor.
E9
：
Communication error,
(1)
Console & controller communication error, check the system cable.
