ASSEMBLY
Assembly requires two persons.
Set the treadmill in a cleared area and remove the packing materials; do not
dispose of the packing materials until assembly is completed. Note: The underside of the treadmill walking belt is
coated with high-performance lubricant. During shipping, lubricant may be transferred to the top of the walking
belt or to the shipping carton. This is a normal condition and does not affect treadmill performance. If there is lu-
bricant on top of the walking belt, wipe it off with a soft cloth and mild, non-abrasive cleaner.
Assembly requires the included hex keys and your own Phillips screwdriver , rubber mal-
let , adjustable wrench , and wire cutters .
To identify assembly hardware, see the drawings below. The number in parentheses below each drawing is the
key number of the part, from the PART LIST near the end of the manual. The number following the parentheses
is the quantity used in assembly.
To avoid damaging plastic parts, do not use power tools for assembly.
Nut (47)–4
Frame Bolt (32)–2
3/4" Screw (2)–6
Upright Bolt (40)–4
Frame Washer
(33)–2
1/4" Star Washer
(21)–2
Handrail Bolt (20)–4
Silver Ground
Screw (27)–2
Wheel Spacer
(44)–4
Console
Bolt (22)–2
Handrail Star
Washer (19)–4
Upright Star
Washer (39)–4
Wheel Bolt (95)–2
Frame Bolt (32)–2
1. Orient the Base (48) as shown.
Identify the Right Upright (36), which has a
square hole near the lower end.
Orient the Right Upright (36) as shown, and
attach it to the Base (48) with two Upright Bolts
(40) and two Upright Star Washers (39);
do not
tighten the Upright Bolts yet.
48
Square
Hole
40
40
39
39
36
1
6
