9
7. Route the Upright Wire (28) through one of the
Handrails (18) as shown, and remove the wire
tie from the Upright Wire.
Attach the Handrail (18) to the Right Upright (36)
with two Handrail Bolts (20) and two Handrail
Star Washers (19).
Be careful not to pinch the
Upright Wire (28).
Attach the other Handrail (18) to the Left Upright
(31) with two Handrail Bolts (20) and two
Handrail Star Washers (19).
31
28
Wire Tie
20
19
18
20
19
18
7
28
18
8. While another person holds the Console Base
(26) near the right Handrail (18), attach the
ground wire on the Console Base to the right
Handrail with a Silver Ground Screw (27).
Connect the wire harness on the Console Base
(26) to the Upright Wire (28) as shown in the
inset drawing.
If the connectors are oriented
correctly, they will slide together easily and
snap into place.
If it does not, turn the end of the
Wire Harness and then insert it.
IF THE CON-
NECTOR IS NOT INSERTED PROPERLY, THE
CONSOLE MAY BE DAMAGED WHEN THE
POWER IS TURNED ON.
27
26
Ground
Wire
28
Wire
Harness
8
22
9. Insert the wires into the Console Base (26) as
you set the Console Base on the Handrails (18).
Be careful not to pinch the wires.
Next, thread
two Console Bolts (22) with 1/4" Star Washers
(21) into the Handrails and the Console Base;
do not tighten the Console Bolts yet.
Attach the Console Base (26) to the Handrails
(18) with four 3/4" Screws (2).
Then, tighten
the two Console Bolts (22).
2
22
21
21
2
18
18
9
26
Front View
36
