7
50
8
38
6. While another person holds the Console (23) in the
position shown, connect the wire harness on the
Console to the Extension Wire Harness (44). Insert the
excess wire harness into the Upright Extension (73).
Attach the Console (23) to the Upright Extension (73)
with three M10 x 27mm Button Screws (67) and three
M10 Split Washers (59).
Be careful to avoid pinch-
ing the wire harnesses.
Snap the bookrack onto the Console (23) in the indi-
cated location.
6
23
67
73
59
59
7. Identify the Left Handlebar (6), which is marked with a
sticker. Insert the Left Handlebar into one of the
Handlebar Arms (5);
make sure that the Handlebar
Arm is turned so the hexagonal holes are on the
indicated side
. Attach the Left Handlebar to the
Handlebar Arm with two M8 x 45mm Button Bolts (50)
and two M8 Nylon Locknuts (38).
Make sure that the
Nylon Locknuts are inside of the hexagonal holes.
Do not fully tighten the Button Bolts yet.
Apply a small amount of the included grease to the left
and right axles on the Upright (2).
Make sure that there are two Small Handlebar
Bushings (49) in the Left Handlebar (6). Carefully slide
an Upright Spacer (48), a Handlebar Spacer (47), the
Left Handlebar, and a Handlebar Cap (46) onto the left
axle on the Upright (2) as shown. Slide a Handlebar
Washer (55) onto an M8 x 19mm Button Screw (56), and
tighten the Button Screw into the axle.
Assemble the Right Handlebar (8) and the other
Handlebar Arm (5) in the same way.
Grease
7
44
Wire Harness
67
Bookrack
67
47
49
5
2
5
55
46
56
6
48
8
63
12
13
8. Attach a Pedal (13) to the Left Pedal Arm (12) with two
M6 x 20mm Pedal Screws (63) as shown. Note: The
Pedal can be attached in any of three positions (see
HOW TO ADJUST THE PEDALS AND THE UPRIGHT
on page 9).
Attach the other Pedal (not shown) to the Right Pedal
Arm (not shown) in the same way. Make sure that both
Pedals are attached in the same position.
Hexagonal
Holes
