8
10. Make sure that all parts of the elliptical crosstrainer are properly tightened. Note: Some hardware may
be left over after assembly is completed. To protect the floor or carpet from damage, place a mat under the
elliptical crosstrainer.
8. Apply a small amount of grease to the axle on the left
Crank Arm (36). Slide the Left Pedal Leg (14) onto the
axle. Slide an M10 Bracket Washer (94) onto an M10 x
25mm Patch Screw (52), and tighten the Patch Screw
into the axle.
Attach the Right Pedal Leg (not shown) to the right side
of the elliptical crosstrainer in the same way.
9. Position a Cushion (88) in one of the adjustment holes
in the Left Pedal Leg (14). Set the Left Pedal Arm (15)
on the Cushion, with the end of the Pedal Arm inside of
the angled bracket on the Pedal Leg. Slide a Plastic
Washer (19) between the Pedal Arm and the Pedal
Leg. Insert the long part of the M10 Bolt Set (27)
through the Pedal Leg, Plastic Washer, and Pedal Arm.
Lift the Left Pedal Leg (14) and hold the left Handlebar
Leg (79) inside of the bracket on the Left Pedal Arm
(15). Slide the other Plastic Washer (19) between the
Pedal Arm and the Pedal Leg. Insert the long part of
the M10 Bolt Set (27) through the Handlebar Leg,
Pedal Arm, Plastic Washer, and Pedal Leg. Tighten the
short part of the Bolt Set into the long part.
Attach the Right Pedal Arm (not shown) to the Right
Pedal Leg (not shown) and the right Handlebar Leg
(79) in the same way.
Tighten the M6 x 25mm Screw (63) into the Upright (2).
Turn the Upright Knob (91) clockwise until it is tight.
Refer to step 6. Tighten the M8 x 45mm Button Bolts
(83) in the Handlebar Legs (79).
36
14
52
94
8
9
Grease
27
14
27
88
79
91
79
63
19
19
2
15
Grease
