5
2
75
1
72
28
56
1. Attach the Front Stabilizer (2) to the front of the
Frame (1) with two M8 x 70mm Carriage Bolts (72),
two M8 Curved Washers (28), and two M8 Nylon
Locknuts (56). Make sure that the Front Stabilizer is
turned so the Roller (75) is
not
touching the floor.
2. Attach the Rear Stabilizer (3) to the rear of the
Frame (1) with two M8 x 85mm Carriage Bolts (63),
two M8 Curved Washers (28), and two M8 Nylon
Locknuts (56).
3. While a second person holds the Upright (6) near
the Frame (1), connect the Extension Wire Harness
(18) to the Lower Wire Harness (44).
Carefully slide the Upright (6) onto the Frame (1).
Be careful to avoid pinching the wires.
Attach the
Upright with four M8 x 15mm Button Screws (74)
and four M8 Black Flat Washers (57).
Important:
Make sure that the Upright is turned exactly as
shown at the right.
2
3
63
3
6
74
74
57
57
44
1
18
57
57
28
28
56
56
1
1
Upright must
be turned as
shown
