5
ASSEMBLY
To hire an authorized service technician to assemble the exercise cycle, call toll-free 1-800-445-2480.
Assembly requires two persons.
Place all parts of the exercise cycle in a cleared area and remove the packing
materials. Do not dispose of the packing materials until assembly is completed.
Assembly requires the included
tools and your own adjustable wrench
and Phillips screwdriver
.
Use the drawings below to identify the small parts needed for assembly. The number in parentheses below each
drawing is the key number of the part, from the PART LIST near the end of this manual. The number following
the key number is the quantity needed for assembly.
Note: Some small parts may have been preassembled.
If a part is not in the parts bag, check to see if it has been preassembled.
M8 Locknut
(10)–6
M8 Split Washer
(41)–10
M10 Locknut
(33)–4
M4 x 16mm
Screw (49)–4
M8 x 25mm Button
Screw (45)–6
M10 x 75mm Carriage Bolt (30)–4
M8 x 38mm Button
Screw (9)–2
1. Identify the Front Stabilizer (2).
See the inset drawing.
Orient a Wheel (14) as shown
and attach it to one end of the Front Stabilizer (2) with
an M8 Locknut (10).
Make sure that the Wheel turns
freely.
Next, align the four posts on a Wheel Cover
(23) with the posts on the Wheel, and press the Wheel
Cover onto the Wheel.
Assemble the other Wheel
(not shown) in the same way.
While another person lifts the front of the Frame (1),
attach the Front Stabilizer (2) to the Frame with two
M10 x 75mm Carriage Bolts (30) and two M10
Locknuts (33) as shown.
2
33
30
1
1
2
14
23
10
Post
