Healthrider HRTL12992, User Manual

26

PROBLEM

SOLUTION

a. 

If the walking belt has shifted to the
left,

first remove the key and 

UNPLUG

THE POWER CORD

. Using the allen

wrench, turn the left rear roller adjustment
bolt clockwise, and the right bolt counter-
clockwise, 1/4 of a turn each. Be careful
not to overtighten the walking belt. Plug in
the power cord, insert the key and run the
treadmill for a few minutes. Repeat until
the walking belt is centered.    

b. 

If the walking belt has shifted to the
right,

first remove the key and 

UNPLUG

THE POWER CORD

. Using the allen

wrench, turn the left rear roller adjustment
bolt counterclockwise, and the right bolt
clockwise, 1/4 of a turn each. Be careful
not to overtighten the walking belt. Plug in
the power cord, insert the key and run the
treadmill for a few minutes. Repeat until
the walking belt is centered.

c. 

If the walking belt slips when walked
on,

first remove the key and 

UNPLUG

THE POWER CORD

. Using the allen

wrench, turn both rear roller adjustment
bolts clockwise, 1/4 of a turn. When the
walking belt is correctly tightened, you
should be able to lift 

the edges

of the

walking belt 3 to 4 inches off the walking
platform. Be careful to keep the walking
belt centered. Plug in the power cord, in-
sert the key and run the treadmill for a few minutes. Repeat until the walking belt
is properly tightened.

a. Remove the key from the console and

UN-

PLUG THE POWER CORD.

Next, remove

the screws from the hood and carefully re-
move the hood. Locate the Reed Switch
(26) and the Magnet (85) on the left side of
the Pulley (28). Turn the Pulley until the
Magnet is aligned with the Reed Switch.

Make sure that the gap between the
Magnet and the Reed Switch is about
1/8Ó.

If necessary, loosen the Reed Switch

Screw (20) and move the Reed Switch slightly. Retighten the Screw. Re-attach the
hood and run the treadmill for a few minutes to check for a correct speed reading.

a. Due to variations in humidity and temperature, there is a possibility that 

bubbles may form in the walking belt. Although the bubbles will disappear with
time, you may unplug the power cord, carefully insert a needle into the bubbles,
and push the air out of the bubbles.

a

b

c

4. The walking belt is 

off-center or slips 
when walked on

5. The displays of the

console do not func-
tion properly

6. Bubbles form in the

walking belt 

85

26

20

Top 

View

1/8Ó

28