6
5. Move your right hand to the position shown at the right,
and hold the treadmill firmly. Using your left hand, lift the
storage latch. Raise the treadmill until the locking pin
snaps into the storage latch. Make sure that the locking
pin is inside the storage latch, and that the storage
latch is fully closed.
6. See drawing 6B. Attach a Base Pad (73) to the bottom of
the Stabilizer Plate (88) in the indicated location.
See drawing 6A. Stand behind the treadmill. Hold the Left
Crossbar Bracket (4) and the Right Crossbar Bracket (not
shown). Place one foot on the Base (75) in the indicated
location.Tip the treadmill back slightly. While the treadmill
is held in this position, a second person should slide the
Stabilizer Plate (88) onto the Base (see drawing 6C).
Keeping your foot on the Base, carefully tip the treadmill
up until it is resting on the Base. Make sure that the
Stabilizer Plate (88) stays on the Base.
See drawing 6C. Attach the Stabilizer Plate (88) to the
Base (75) with a Stabilizer Plate Bolt (105), two Washers
(97), and the Stabilizer Plate
Nut
(95) as shown.
Before moving the treadmill, see HOW TO MOVE THE
TREADMILL on page 11.
7. Refer to assembly drawing 5 at the top of this page. Hold
the upper end of the treadmill with your right hand as
shown. Using your left hand, lift the storage latch. Pivot
the treadmill slightly until the locking pin is out of the stor-
age latch.
Hold the treadmill firmly with both hands, and lower the
treadmill to the floor. To decrease the possibility of in-
jury, bend your legs and keep your back straight.
8. Remove the paper backing from the Adhesive Clip (44).
Press the Adhesive Clip onto the Frame (84) in the indi-
cated location. Press the Allen Wrench (57) into the
Adhesive Clip. The use of the Allen Wrench is described
on page 13.
Make sure that all parts are tightened before you use the
treadmill. Note: Place a mat beneath the treadmill to pro-
tect the floor or carpet.
4
88
75
Storage Latch
Locking Pin
5
6A
8
44
84
57
7
88
97
95
105
88
73
6B
6C
75
