Select Measurement Unit
4
When batteries are correctly installed, press “UNIT” button at the back side of
the scale inside battery chamber to select measurement UNIT. The default
measurement unit is “kg”. You may press “UNIT” button to choose among
kilogram, pound and stone.
3
HealthSense Ultra-Lite body fat monitor BF-414 applies BIA (Bio-
impedance Analysis) technology. A small amount of weak current flows
through the human body so as to detect the bio-impedance and estimate
body fat %, body water %, muscle mass %, bone mass and calories
recommended. The electrical current is small and may not be felt.
This BIA technology is cheap, safe, non-invasive, toxic-free and harmless. It
also possesses the characteristics of simple operation and abundant
information.
The current mentioned above is less than 1mA. However, please be aware
that anyone with an wearable or implantable medical electronic instrument,
such as a pacemaker, must avoid using this device.
The intended use of this device is for healthy children 10-17 years old and
healthy adults
General Instructions
Open the battery door at the back of the scale.
Insert the Batteries
Close the battery door and wait until the digits
“0.0”are shown on the LCD.
Insert the batteries (2 x AAA ) into the battery
compartment according to the polarity
indications marked inside the compartment.
* The icons “8888” will be shown on the LCD.
When the symbol “ Lo ” appears, the device will power off in four seconds. Then you should
replace with a new set of batteries. Please replace both batteries at the same time. DO NOT mix
the old batteries with the new one.
Worn batteries are hazardous waste. DO NOT dispose of them together with the household
garbage. Please refer to the local ordinances and recycling instructions regarding disposal of the
worn batteries and scrapped device.
If you do not intend to use this unit for a prolonged period of time, it is advisable to remove the
batteries before storing.
Cautions
After selecting the preferred unit, the scale will be auto-off after 20 seconds. Selected weight
unit will be activated when the scale is turned on again.
When setting kg as weight unit, the default height unit is cm.
When setting lb/st as weight unit, the default height is feet/inch.
kg
lb
kg
st:lb
Note
Initial Startup
Initial Startup
