3-3 Adding SILICON
If necessary use the Hex Wrench to unscrew the bolt inside the Rear End Cap. Then pull the belt up and
daub some SILICON to the center of the board. After that, adjust the belt to the center of the deck, followed
by tightening the screw to the original set. It is suggested to examine the product twice a month.
Function of LUBRICATION REQUIRED
It will remind you to add lubricant when total distance added up to 2000Km(the distance is difference with the levels of
running belt). When restarting the treadmill next time, the character string of “ LUBRICATION REQUIRED＂ will show on
the screen and then into start/ready status after continuously displaying for 1 minute.
Ps: When adding lubricant, check whether the lubricant in the running belt is dried up. If it is, then add lubricant into it.
Cancel the character string of “LUBRICATION REQUIRED＂ displayed on the screen every time you restart the treadmill.
After adding lubricant, restart the power and then it will display the character string of “LUBRICATION REQUIRED＂ for 1
minute on the screen. During the one minute, press speed up key and speed down key at the same time. The number will turn to
0 after 5 seconds and cancel the character string of “LUBRICATION REQUIRED＂ which will display until the next 2000km
reach.
12
2009/10/26 Ver1.0+V2.0
