35
2010/2/26 Ver1.0+V1.0
z
Program Mode
(
When the TV image appears blank or no signal, you can adjust TV system setup in this mode,
and non-engineer is not allowed to change the parameters of this mode to avoid error
):
Under start/ready mode, press
and then press
.
↓
DTV Setup Steps:
1.
DTV System
:
There are DVB and ATSC system specs according to regions.
2.
Enter into DTV Setup.
3.
After selected language and country, press confirmation key(key instructions--ENTER
:
confirmation key
;
+/- key
:
up/down key
;
/- key
:
switch items
;
CLEAR key
:
back to the last menu)
4.
It will display ”Do you want to install?” If you choose Yes, it will SCAN automatically.
5.
If you want to SCAN again
,
enter into DTV Setup and then press PAUSE to enter into Main
Menu.
6.
After selected Digital TV
,
press ENTER key.
Simulation Signal Setup Steps
:
1.
TV System
:
There are NTSC/PAL
system specs according to countries.
2. RF System
:
AIR/CABLE
,
Please
first confirm the input system is
CATV or AIR.
3.
“TV Search” Channel scan
function(This function can eliminate
the channel with no signal) Confirm
the above setup and press this key
and menu will begin to scan
automatically. The setup will be
finished after 10 seconds
4.
Turn off and restart to store the set
value.
Choose’’5’’TV setup
Summary of Contents for HC10TVUB
